- 314-567-3100
- 1643 Lotsie Blvd. St. Louis, MO 63132
Menu
MODEL LT 2000
SPACE-SAVING SURFACE TREATER FOR 3D PARTS — ORIENTED & NON-ORIENTED
The LT 2000 is smaller than and as powerful as a standard LectroTreat with the same tunnel dimensions. It can be used in bulk or in-line applications. The LT 2000 features all the benefits of our standard open air plasma discharge system at a fraction of the cost.
LT 2000 FEATURES & BENEFITS
Surface Treatment Levels >70 dynes/cm over the entire outside of three-dimensional plastic parts. Allows for decoration/adhesion on plastic parts without the use of costly primers or chemical wipes.
Zero scrap due to heat warping, surface crazing, stress relieving, and paneling. Maintains the surface integrity of plastic parts. Thin walling of parts results in material savings.
No setup required for different shapes results in labor and production savings.
Continual process. No vacuum required. Higher production rates.
Lower insurance premiums; no open flames.
Low cost power construction.
No interference with electronic/PLC/computer controls.
Interfaces with entire production line for reliable and repeatable production rates.
Guaranteed 360-degree uniform surface treatment.
Input Voltage: Standard 240 volt, 3 phase, accommodates any voltage
Frequency: 50-60HZ.
Total Electrical Load: 5 KVA on standard units
Certification: UL, CSA or CE components
Equipment Dimensions: 38” wide x 72” long x 60” high; 12” conveyer extension each end
Conveyor Height: 37” above the floor
Complete Systems: Surface treating, conveyor, and exhaust systems included on standard unit; custom designs available upon request
Specifications are subject to change without notice. Guards are supplied and must be in place before operation. All sales are subject to our prevailing terms and conditions of sale. Other options available upon request.
